Configuring and starting Spread
I already have vertica installed in AWS and after days of troubleshooting I discovered that I needed to -T option in install_vertica to configure point to point. Can I get some help on:
1) how to re-configure spread to use -T (point to point)?
2) how to restart?
I tried using
[[email protected] ~]# /opt/vertica/sbin/update_vertica -s host1,host2,host3 -r ./v/vertica-7.1.1-0.x86_64.RHEL5.rpm -u vertica -T --failure-threshold NONE
but I see this message when I run the update:
Running upgrade logic
No spread upgrade required: /opt/vertica/config/vspread.conf not found on any node
But I do see vspread.conf in catalog directory but not sure how to configure it.